Sango Materials List

Hulls and foredecks 36 sq m x 8mm western red cedar strip 50mm wide strips
11 sq m x 8mm western red cedar strip 25mm wide strips
5m 3" x 2" cedar for outer stems.
50kg 400g biaxial glass (must be compatible with epoxy).
70kg epoxy glue. 10kg polyurethene glue (for glueing strips). Glass and epoxy also used for some decking joints.
25L epoxy hi-build paint (recommend two different colours) plus ordinary fillers as reqd.

Bulkheads, bunk tops wings etc 6 mm ply 7 sheets

Beams, beam boxes 6 mm ply 4 sheets
Aft decks, dagger board boxes 6 mm ply 3 sheets

Daggerboards 18 mm ply 2 sheets

Central cuddy 9 mm ply 4 sheets 6 mm ply 6 sheets 4 mm ply 6 sheets

Cockpit 9 mm ply 3 sheets 6 mm ply 2 sheets

Use best quality gaboon throughout. Plywood should be BS 1088 or equiv. Sheet sizes are 8’ x 4’.

TIMBER:
200m 2’’ x 1’’ (some is ripped down to make 1’’ x 1’’ when reqd)
Use yellow cedar, sitka spruce or similar unless noted.
Note sizes are nominal & should be planed all round, i.e. final size of 1’’ x 1’’ = 20 x 20 mm.

MISC:
Approx 1000g 1’’ Gripfast nails,1000g 3/4’’ gripfast nails. 200 1’’ x no 8 brass screws, approx 20 3’’ brass screws
Paint as required for min of 3 coats on outside, 2 coats on inside.
1 sheet 8’ x 4’ 6mm perspex for windows, washboard.
Large timbers (eg 6’’ x 3’’) for building frame - 15m required 3 sheets 12mm ply (min thickness) for building frames.

Note: Materials list excludes waste