Strip Plank Cedar
Decks
9mm Ply 20 sheets 2" x 1" 150m, 3" x 1" 250m, 1" x 1" 100m
Cuddy, Cockpit
12mm Ply 12 sheets, 9mm Ply 14 sheets, 6mm Ply 6 sheets, 4mm Ply 12 sheets,
2" x 1" 70m, 3" x 1" 40m, 2" x 2" 15m, 4" x 2" 6m
Hulls
Sheet Ply 9mm Ply 40 sheets, 3" x 1" 350m, 11/2" x 3/4" 250m or 80 sheets 4mm ply if rounded V, or 4mm Ply 40 sheets 9mm Ply 20 sheets if round bilge ply hulls built
Strip Cedar
12mm Western Red Cedar 85m2, 70mm wide strips cut down to 35mm in round bilge area
800g Biaxial glass 100Kgs (outside skin), 600g Biaxial glass 70Kgs (inside skin) . Epoxy 200Kgs
Glue, Glass etc
300g glass cloth for sheathing decks and ply hulls 80Kgs, epoxy glue 120Kgs. 40Kgs cloth, 60Kgs glue for sheathing decks if cedar hulls used. 50Kgs epoxy for general glueing, plus fillers as reqd. Or use Polyurethene glue for low loaded joints, approx 20Kgs reqd.
Interior
6mm Ply 10 sheets Marine Ply (gaboon) 9mm Ply 15 sheets Marine Ply (gaboon)
2" x 1" softwood approx 200m, this can be ripped down for 1" x 1"
Beams, Bulkheads
12mm Ply 8 sheets, 9mm Ply 26 sheets 2" x 2" 90m, 3" x 2" 45m, 3" x 1" 10m, 2" x 1" 25m
Foam Sandwich Round Bilge
Decks
12mm rigid foam (eg Termanto or Divinycell) 92m2
20mm rigid foam 35m2
Hulls
12mm Airex (flexible foam) 45m2
12mm contour foam 46m2 (note: Some deck panels can be made using contour foam if gel coat finish required)
Glass
600/300 Rovimat 700Kg
600g CSM 100Kg
300g CSM 50Kg
Resin
Gel coat 30Kg
Laminating resin 1300Kg
Interior
6mm Ply 10 sheets Marine Ply (gaboon)
9mm Ply 15 sheets Marine Ply (gaboon)
2" x 1" softwood approx 200m, this can be ripped down for 1" x 1"